Shovelhead Staggered Dual Exhaust Systems For 1966 - 1969 Swingarm Frames

Staggered Dual Exhaust Systems For 1966 - 1969 Swingarm Shovelheads
An outside-the-frame front pipe, and a rear pipe that routes in front of the transmission, guarantee classic style and a throaty sound. These complete systems fit all 1966–1969 Shovelhead engines in swingarm frames, and will also fit rigid frames if the
mechanical brake crossover tube is removed. The 40"-long drag pipes and the pipe sets with mufflers, have slider channels to ease installation.

2"-DIAMETER DRAG PIPES

723-2IN40 40"-long Slash Cut drag pipes (use Paughco #725D clamps to install) not shown

1-3/4"-DIAMETER EXHAUST SYSTEMS

723 34"-long Slash Cut drag pipes (use Paughco #725D clamps to install) not shown
723A 34"-long Goose Cut drag pipes (use Paughco #725D clamps to install) shown below on bike
723-40 40"-long Slash Cut drag pipes
723M 38"-long Slash Cut muffler set
723GM 38"-long Goose Cut muffler set
723TM 38"-long Tapered muffler set
422R Rear heat shield for Paughco #723 series pipe sets (shown below on bike)

 

Special Notes:
1) Drag pipes are not recommended for use on the street.
2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns. Do not use these pipes unless the front end is extended at least 4" longer than stock or serious injury may result.
3) See page 247 for P-clamps and frame rail clamps to install these pipe sets.