Panhead Shotgun Exhaust Systems For 1958 - 1964

1-3/4" Panhead Shotgun Exhaust Systems For 1958 - 1964 

These complete systems fit 1958–1964 swingarm frames with electric or kickstart and swing-out kicker ONLY. They will not fit with a large FLH battery. They all have slider channels so you can use a Paughco #718J bracket (sold separately) to install the rear pipe (see page 263). A heat shield for the rear pipe is highly recommended.

 

721D1-40 40"-long Slash Cut drag pipes (shown below on bike)
721D1GM 38"-long Goose Cut muffler set
721D1M 38"-long Slash Cut muffler set
721D1TM 38"-long Tapered muffler set
412D1R Rear heat shield for Paughco #721D1 series pipe sets (shown below on bike)
718J Hanger bracket for the rear pipe on Paughco #721D1 series pipe sets (shown below
on bike)

 

Special Notes:
1) Drag pipes are not recommended for use on the street.
2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns. Do not use these pipes unless the front end is extended at least 4" longer than stock or serious injury may result.
3) See page 247 for P-clamps and frame rail clamps to install these pipe sets.
4) See pages 349-353 for photos of the heat shields for these pipe sets.