Panhead Over The Transmission Exhaust Systems For 1948-1964

1-3/4"  Panhead Over The Transmission Exhaust Systems For 1948-1964 

An outside-the-frame front pipe, and a rear pipe that routes over the transmission, bring a modern style and a throaty sound to your 1948–1964 Panhead. These systems will fit rigid or swingarm frames, but will not fit with large FLH battery. They all have slider channels.

721C40 40"-long Slash Cut drag pipes
721CGM 38"-long Goose Cut muffler set (shown on bike)
721CM 38"-long Slash Cut muffler set
721CTM 38"-long Tapered muffler set
421CR Rear heat shield for Paughco #721C series pipe sets (shown on bike)

 

Special Notes:
1) Drag pipes are not recommended for use on the street.
2) These pipes have less ground clearance than original equipment and may scrape on hard right hand turns. Do not use these pipes unless the front end is extended at least 4" longer than stock or serious injury may result.
3) See page 247 for P-clamps and frame rail clamps to install these pipe sets.
4) See pages 349-353 for photos of the heat shields for these pipe sets.